TCIKIT and TCIKITC are RoHS Compliant.
Custom Transducer Interface
Do-it-yourself, custom transducer connector interface kits
TCIKITC 5 pin – 1.5 mm Touchproof female pins
- Use to connect non-BIOPAC electrodes and transducers directly to BIOPAC biopotential or transducer amplifier modules—except DA100C or DA100A. Color-coded wires are soldered to each of the five input sockets (Shield, Vin+, GND, Vin-, Shield).
TCIKIT 7 pin – 2 mm male pins
- Use for DA100C or DA100A. Kit includes housing, PC board with 7 attached PIN plugs (2 mm) and instructions, and is partially assembled; mount a connector to the housing and solder wires to the pin.
Details
Support
Applications
Downloads/Resources
Knowledge Base
- * CLEANING GUIDELINES *
- About License Keys
- AC mode
- AcqKnowledge accuracy
- AcqKnowledge iLok key lost or unavailable
- Amplifier analog output signals
- Amplifier filter settings
- Arbitrary waveform stimulation
- Band-pass and band-stop filters
- BioNomadix Signal Interruption
- Calculating file sizes
- Calibration values
- Checking Finger Cuff Lifetime for NIBP100D/NIBP100D-HD
- Common mistakes/general troubleshooting
- Connecting Calibration Gas Tanks & Mixing Chambers
- Editing noisy data
- Electrodermal activity measurements
- Event Markers | Correcting Automated Placement
- Excel files exported from BIOPAC software open in Excel 'Protected View'
- Glossary of specification terminology
- Grounding guidelines
- High pass filters
- How can I move QRS peak event marks from the bottom of S waves to the top of R waves?
- Installation CD/DVD lost or damaged...how can I re-install software?
- Interfacing third-party transducers
- Low pass filters
- Notch filter
- Railing signal (flatline)
- Recording good data
- Troubleshooting MP160 Ethernet Communication
- Using other software with BIOPAC hardware
- VREF, reference excitation voltage
Stay Connected