Part #: CBLETH1, CBLETH2
Ethernet Cables
Use CBLETH1 Ethernet patch cable and CBLETH2 crossover cable with MP160 and MP150 data acquisition units.
- For MP160:
The network interface of MP160 uses Auto MDI/MDIX and so can use CBLETH1 or CBLETH2 no matter whether the MP160 is connected through a switchbox. - For MP150:
– Use one CBLETH1 to connect the MP150 to an Ethernet Switch and one CBLETH1 to connect the Switch to a local area network (LAN).
or
– Use CBLETH1 to connect the MP150 to an Ethernet interface (such as the ETHUSB interface shipped with your MP System).
Details
Support
Downloads/Resources
Knowledge Base
- * CLEANING GUIDELINES *
- About License Keys
- AC mode
- AcqKnowledge accuracy
- AcqKnowledge iLok key lost or unavailable
- Amplifier analog output signals
- Amplifier filter settings
- Arbitrary waveform stimulation
- Band-pass and band-stop filters
- BioNomadix Signal Interruption
- Calculating file sizes
- Calibration values
- Checking Finger Cuff Lifetime for NIBP100D/NIBP100D-HD
- Common mistakes/general troubleshooting
- Connecting Calibration Gas Tanks & Mixing Chambers
- Editing noisy data
- Electrodermal activity measurements
- Event Markers | Correcting Automated Placement
- Excel files exported from BIOPAC software open in Excel 'Protected View'
- Glossary of specification terminology
- Grounding guidelines
- High pass filters
- How can I move QRS peak event marks from the bottom of S waves to the top of R waves?
- Installation CD/DVD lost or damaged...how can I re-install software?
- Interfacing third-party transducers
- Low pass filters
- Notch filter
- Railing signal (flatline)
- Recording good data
- Troubleshooting MP160 Ethernet Communication
- Using other software with BIOPAC hardware
- VREF, reference excitation voltage
Stay Connected