Part #: FOTS100A-ADAPT
FOTS100A Sensor Adapter
This sensor adapter is required for the FOTS100A System “HandySens” module to accept temperature probes TS180, TSD181, or TSD182.
Note Temperature probes with “A” suffix—TSD180A, TSD181A, and TSD182A—are directly compatible with the FOTS100A System “HandySens” module without an adapter, but they are not compatible with the older FOTS100 System. Labs that have both FOTS100A and FOTS100 need the adapter to use TSD180, TSD181, and TSD182 with the newer system.
Details
Support
Downloads/Resources
Knowledge Base
- * CLEANING GUIDELINES *
- About License Keys
- AC mode
- AcqKnowledge accuracy
- AcqKnowledge iLok key lost or unavailable
- Amplifier analog output signals
- Amplifier filter settings
- Arbitrary waveform stimulation
- Band-pass and band-stop filters
- BioNomadix Signal Interruption
- Calculating file sizes
- Calibration values
- Checking Finger Cuff Lifetime for NIBP100D/NIBP100D-HD
- Common mistakes/general troubleshooting
- Connecting Calibration Gas Tanks & Mixing Chambers
- Editing noisy data
- Electrodermal activity measurements
- Event Markers | Correcting Automated Placement
- Excel files exported from BIOPAC software open in Excel 'Protected View'
- Glossary of specification terminology
- Grounding guidelines
- High pass filters
- How can I move QRS peak event marks from the bottom of S waves to the top of R waves?
- Installation CD/DVD lost or damaged...how can I re-install software?
- Interfacing third-party transducers
- Low pass filters
- Notch filter
- Railing signal (flatline)
- Recording good data
- Troubleshooting MP160 Ethernet Communication
- Using other software with BIOPAC hardware
- VREF, reference excitation voltage
Stay Connected